A flowing sheer curtain covering the glass on a door can be a nuisance as it tends to get caught when the door is used. Adding a second rod at the lower edge solves this problem but when it is tied in the centre with a bow of ribbon you can create a focal point from an ordinary door. To achieve the best results allow 2 - 2½ times the width of the rod and cut the top and bottom of the fabric on a curve. They are also ideal for covering French or patio doors and windows.
These free illustrated instructions will enable you to make your own hourglass curtain.

Requirements:

Any lightweight fabric including sheers and nets.

2 net rods or wires.

Matching thread.

Ribbon approximately 2" (5 cms) wide.

Cutting out and making up:

Attach the rods approximately 1" (2.5 cms) above and below the glass.

Measure length between rods, CL.

Mark the glass half way between the rods.

Determine the width of the "waist" and mark the glass.

To calculate the outer length of the curtain measure the curve from the end of the top rod to the end of the bottom rod curving the tape in to the end of the marked "waist" OL.

Cut fabric to OL plus 8" (20 cms) for hem allowance.

To neaten sides, if necessary, turn under a double ½" (13 mm) hem and stitch.

Fold curtain in half lengthways.

Measure OL minus CL down from the top along the folded edge and mark.

Draw a curve from this mark to outer corner.

Repeat steps 9 and 10 for lower edge.

Cut along curves at top and lower edges.

To sew casings turn under 1" (2.5 cms) and then another 2" (5 cms) at top and lower curves and pin.

Work a first row of stitches 1" (2.5 cms) in from fold and another row of stitches 2" (5 cms) from fold. Do this at both top and lower edges. Press.

Thread net rods between rows of stitches and adjust pleats evenly.

Tie ribbon bow around the centre of the curtain to form "waist".